Rockwell Automation Publication IASIMP-QS023B-EN-P - December 2012 33
Chapter 2
Prepare the Computer and Load Controller Firmware
In this chapter, you install and configure the necessary programming and configuration software
on your computer and load firmware on your controller.
Before You Begin
Before you begin, complete these tasks:
• Verify that your computer meets the software’s system requirements for installation and use
of the software listed in Ta ble 5
.
• The tasks described in Chapter 1, Prepare the CompactLogix 5370 L3 Controller
Hardware on page 17, including the following:
– Install the EtherNet/IP and/or the DeviceNet network.
– Assemble the system.
– Make network connections.
– Wire power to the controller.
To Next Page
Loading...
Need help?
General
