Preface
MicroLogix 1000 Programmable Controllers User Manual
D–18
Software Considerations
Software considerations include the configuration of the network and the parameters
that can be set to the specific requirements of the network. The following are major
configuration factors that have a significant effect on network performance:
• number of nodes on the network
•
addresses of those nodes
• baud rate
The following sections explain network considerations and describe ways to select
parameters for optimum network performance (speed). See your programming
software’s user manual for more information.
Number of Nodes
The number of nodes on the network directly affects the data transfer time between
nodes. Unnecessary nodes (such as a second programming terminal that is not
being used) slow the data transfer rate. The maximum number of nodes on the
network is 32.
Setting Node Addresses
The
best network performance occurs when node addresses are assigned in
sequential order
. Initiators, such as personal computers, should be assigned the
lowest numbered addresses to minimize the time required to initialize the network.
The valid range for the MicroLogix 1000 controllers is 1–31 (controllers cannot be
node 0). The default setting is 1. The node address is stored in the controller status
file (S:16L).
Setting Controller Baud Rate
The best network performance occurs at the highest baud rate, which is 19200. This
is the default baud rate for a MicroLogix 1000 device on the DH-485 network. All
devices must be at the same baud rate. This rate is stored in the controller status file
(S:16H).
efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
To Next Page
Loading...
Need help?
General
