Rockwell Automation Publication 2711R-UM001E-EN-E - January 2017 109
Troubleshoot the System Chapter 8
Alert 2090 Invalid Control password. Password must contain at least one special
character.
Alert 2091 VNC Server is Disabled. Enable VNC Server to change/reset password.
Alert 2092 Ethernet port is disabled. Go to Port Settings on the terminal to enable the
Ethernet port.
Alert 2093 Serial port is disabled. Go to Port Settings on the terminal to enable the
Serial port.
Alert 2094 Existing VNC client connection will be terminated.
Confirm (Y/N)?
Press Yes to terminate the VNC connection, or No to
cancel.
Alert 2095 Cannot edit recipe for running application. Unload the application and try again.
Alert 2096 Recipe with the same name already exists Make sure the recipe name is unique.
Alert 2097 Recipe Name cannot contain more than 31
characters. Please choose another name.
Make sure the recipe name does not exceed 31
characters.
Alert 2098 The Name cannot be blank and must contain only
alphanumeric characters plus [ $'@!()_- ].
Make sure the name contains only alphanumeric
characters plus [ $'@!()_- ].
Alert 2099 Deletion of a recipe in a design secured
application is not allowed. Refer to user manual.
Make sure the application is not design secured.
Alert 2100 Renaming of a recipe in a design secured
application is not allowed. Refer to user manual.
Make sure the application is not design secured.
Alert 3001 Available memory is too low to run the
application.
Please try to release some memory or this may lead
to fatal error.
Multilanguage 8193 Language switch ignored. Application was not
configured with new language. An attempt was
made to switch to a language that is not
configured for this application.
Either add the specified language and associated
strings or remove the unconfigured language
selection.
PanelView 800 Terminal Alerts
Category ID Description Corrective Action
To Next Page
Loading...
Need help?
General
