Allen-Bradley PowerFlex 70 Reference Manual

2-128 Owners
Conversely, any number of adapters can simultaneously issue Stop
Commands. Therefore, Stop Ownership is not exclusive.
Example:
The operator presses the Stop button on the Local HIM to stop the drive.
When the operator attempts to restart the drive by pressing the HIM Start
button, the drive does not restart. The operator needs to determine why the
drive will not restart.
The operator first views the Start owner to be certain that the Start button on
the HIM is issuing a command.
Start Owner
When the local Start button is pressed, the display indicates that the
command is coming from the HIM.
Start Owner
The [Start Owner] indicates that there is not any maintained Start
commands causing the drive to run.
Stop Owner
The operator then checks the Stop Owner. Notice that bit 0 is a value of “1,”
indicating that the Stop device wired to the Digital Input terminal block is
open, issuing a Stop command to the drive.
Until this device is reclosed, a permanent Start Inhibit condition exists and
the drive will not restart.
Also refer to Start Inhibits
and Start Permissives.
00000000
Adapter # X6543210
00000010
Adapter # X654321
0
00000001
Adapter # X6543210

Allen-Bradley PowerFlex 70 Specifications

General

Input Voltage	200-240V AC, 380-480V AC, 500-600V AC
Frequency Range	0 - 400 Hz
Humidity	5% to 95% non-condensing
Output Voltage	0 to Input Voltage
Control Methods	Sensorless Vector Control
Communications	Ethernet/IP, DeviceNet, ControlNet
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overtemperature, Ground Fault
Operating Temperature	0°C to 50°C (32°F to 122°F)
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Enclosure Rating	IP20, NEMA Type 1