14 3, 8, or 16 Axis SERCOS interface Module
Publication
1756-IN572E-EN-P – March 2004
Cable Connector Handling and Maintenance
When cables are not in use, keep the ends covered with the dust covers that
came with the cables. This helps to keep dust and small particles from
blocking the optic path. Good system performance is dependent on clean
port optics and cable ferrules to avoid obstructing the optical path. Clean
compressed air is often sufficient to remove particles of dirt. You can also use
methanol on a lint and strand free cotton swab. Recommended cleaners
include:
2090-SCVG25-0 25 m (984 in)
2090-SCVG32-0 32 m (1260 in)
2090-SCVG50-0 50 m (1970 in)
2090-SCVG100-0 100 m (3937 in)
Alcohols Aliphatics Other
methyl hexane soap solution
isopropyl heptane naphtha
isobutyl
ATTENTION
The small junction size inherent in the design of these
components increases the components’ susceptibility
to damage from electrostatic discharge (ESD). It is
advised that normal static precautions be taken in
handling and assembly of these components to
prevent damage and/or degradation which can be
induced by ESD.
Allen-Bradley Catalog
Number
Length in meters
(inches)
To Next Page
Loading...
