Need help?Do you have a question about the Allen-Bradley 1769-SDN and is the answer not in the manual?
Describes how RSNetWorx software is used for configuring the scanner and its slave devices.
Lists compatible software versions and provides installation instructions for configuration tools.
Step-by-step guide to setting up the DeviceNet communication driver within RSLinx.
Covers scanlist setup, node addressing, I/O device configuration, parameters, ADR, and saving.
Details the input file structure, including status areas, failure arrays, and idle/active node status.
Describes the output array, module command array, and mapping of controller output data.
Procedures for assigning node addresses and mapping adapter I/O into the scanner.
Guide to creating a project in RSLogix 5000, configuring I/O modules, and setting up tags.
Discusses compatibility, RSLogix 500 configuration, project setup, and I/O screen details.
Details scanner configuration, changing settings, ignoring errors, and Series/Revision information.
Covers backplane messaging, PCCC, CIP protocols, and procedures for program upload/download.
Table summarizing LED status, indications, and recommended actions for troubleshooting.
Lists error codes displayed by the numeric display and provides solutions for each.
General| Manufacturer | Allen-Bradley |
|---|---|
| Product Type | DeviceNet Scanner |
| Series | 1769 |
| Communication Protocol | DeviceNet |
| Input Voltage | 24V DC |
| Current Consumption | 100 mA |
| Number of DeviceNet Nodes | 63 |
| Shock | 30 g |
| Power Consumption | 2.4 W |
| DeviceNet Baud Rates | 125 kbps, 250 kbps, 500 kbps |
| Operating Temperature | 0°C to 60°C |
| Storage Temperature | -40°C to 85°C |
| Relative Humidity | 5% to 95% (non-condensing) |
| Weight | 0.2 kg |
| DeviceNet Connector | 5-pin removable terminal block |
| Compatibility | CompactLogix 1769 I/O platform |
To Next Page