© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
D1343
16
Machine Foundation
Thoroughness of detail must be stressed with all
foundation work to ensure a stable unit installation,
eliminating possibilities of excessive vibration during
extract.
The machine must be placed on a smooth level surface
so that the entire base of the machine is supported and
rests on the mounting surface.
The standard installation does not require anchoring
unless mandated by state or local codes.
Static and dynamic loads on the floor or foundation are
shown in Table 5 .
Table 5 can be used as a reference when designing
floors and foundations.
If installing a foundation and pad, prepare a form for
the above-ground portion of the foundation. Verify
that the top of the foundation is level. The height of the
foundation and pad must not exceed 8 inches
(203 mm) above the existing floor.
IMPORTANT: Mounting bolts MUST be used for
installation on the models with capacity of 12 lb.
(60 l), 14 lb. (65 l), 18 lb. (75 l) 25 lb. (100 l) 30 lb.
(135 l) and 35 lb. (165 l) models equipped with
steam heat and models installed on metal base
frames. Refer to Mounting Bolt Installation.
Ensure that the machine is installed on a
level floor of sufficient strength and that
the recommended clearances for
inspection and maintenance are provided.
Never allow the inspection and
maintenance space to be blocked.
W488
CAUTION
Floor Load Data
Capacity lb. (l) 12 (60) 14 (65) 18 (75) 25 (100) 30 (135) 35 (165) 55 (235) 75 (305)
Kinetic Energy of the
Cylinder, (N/m)
12488 9075 10024 12538 25900 31315 65604 97806
Dynamic Bottom Load,
(N/Hz)
520/21 570/16 550/16 538/16 1100/16 1450/16 2300/15 2340/15
Table 5
To Next Page
Loading...
