Alliance Laundry Systems CS018 - Out-Of-Balance Switch; Automatic Lubricator

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
33
D1343
Out-of-Balance Switch
Figure 19
The out-of-balance switch is mounted on the upper
right side on the back of the control panel. There is a
window around the probe of the switch that is mounted
on the movable part of the machine.
When the machine goes out of balance by overloading
or uneven distribution of the linen, the out-of-balance
switch will interrupt this action to prevent damage to
the machine.
IMPORTANT: To guarantee good functioning, the
probe should be centered horizontally and
vertically at 1/3 from the bottom of the tilt window
(when machine drum is empty).
Automatic Lubricator
Only for 75 lb. (305 l) Capacity Models
Figure 20
The bearing house of the machine is equipped with a
lubricating device, refer to Figure 20, which
automatically lubricates the bearing during one year.
Upon delivery of the machine, this lubricator has been
brought into use. When replacing, please put on the
matching screw, refer to Figure 20, in the foreseen
opening of the lubricator to activate.
CFS501N
1 Window
2 Probe
1
2
CFS502N
1 Lubricating Device
2 Screw
1
2
Ignoring this instruction will inevitably
cause damage to the bearings and void
the warranty!
W492
WARNING