© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
D1343
20
Mounting Bolt Installation
(If Required)
After the concrete has cured and the anchors are
installed, proceed as follows:
1. Place the machine adjacent to the foundation. Do
not attempt to move it by pushing on the sides.
Always insert a pry bar or other device under the
bottom of the frame of the washer-extractor to
move it.
2. Place the machine carefully over the anchors.
3. Put bolts through the machine in the anchors and
fasten them. For the 12 lb. (60 l), 14 lb. (65 l), 18
lb. (75 l), 25 lb. (100 l), 30 lb. (135 l) and 35 lb.
(165 l) capacity models, the diameter of the bolt
must be minimum 1/2-13 or 12 mm; for the 55 lb.
(235 l) and 75 lb. (305 l) capacity models, the
diameter of the bolt must be minimum 5/8-11 or
16 mm.
4. To level machine, fill the spaces between the
machine base and floor with machinery grout.
Grout completely under all frame members.
Remove front and rear panels to gain access to all
frame members. Force grout under the machine
base until all voids are filled.
5. Allow machine grout to set, but not cure.
6. Remove the spacers carefully, allowing the
machine to settle into the wet grout.
7. Position washers and locknuts on machinery
anchor bolts and finger-tighten to machine base.
8. After the grout is completely cured, tighten the
locknuts by even increments – one after the
other – until all are tightened evenly and the
machine is fastened securely to the floor.
9. Remove the four red transport brackets which
secure the moving components of the machine
during shipping. Refer to Figure 9 and Figure 10
for typical transport bracket locations.
CFS485N
1 Base Frame
2 Bolt
3 Washer
4 Anchor Bolt/Plug
Figure 8
To Next Page
Loading...
