STEP 6: Choosing the program settings
Using the program settings, the washing programs can be further adjusted to your wishes. See chapter:
SETTINGS.
(only appliance owner/distributor may change the settings)
Some program settings may not be available for your selected program.
Start delay
Choose the delayed start when you wish the washing program to start after a certain period of time
(from 1 h to 100 h after you press the Start button).
Use the Program selector knob to set the delay (from 1 hour to 100 hours in 1-hour steps).
Press the button to confirm your selection.
Start delay time + time remaining until the end of the washing program will be displayed. When the
countdown is over, the selected washing program will start .
To cancel the start delay, press the button Cancel.
Then press the Start button to start the program.
When Start delay time is once set, it is not possible to change it; the only possibility is to »Skip it« and
continue with chosen program.
INFORMATION!
If you have set the delayed start function and you are using liquid detergent, we do not recommend
choosing a programme with a pre-wash cycle.
STEP 7: Start the wash
Close the washing machine door and press the Start /Pause button.
Start (pressed briefly – start/resume)
Pause (short press of the button - pause)
Stop (press and hold for 3 seconds – stop or cancel)
Remaining time
Depending on the selected program, anticipated washing time will be displayed in hours and minutes.
Actual washing time will depend on the selected program, load, type of laundry, spin speed etc.
Actual washing time may be longer or shorter than initially displayed.
Remaining time will be updated during the program duration, depending on the actual amount of
laundry and amount of water pumped into the machine. The last remaining time update takes place
before the final spinning cycle.
In case of uneven distribution of laundry, the time on the display will flash and it will not count down.
Once the laundry is evenly redistributed, the washing time will continue and it will stop flashing.
27
To Next Page
