Adding or removing laundry after the start of the program
To add laundry during washing program, you must first select the enable/disable option. (See chapter:
SETTINGS).
To add or remove laundry during the progress of a washing program, use the Start/Pause button
to pause the program.
The door may be opened when the water is pumped from the machine (but not completely pumped
out). Then, add or remove the laundry. Close the door and continue the program. Press the Start
/Pause button.
The program will resume from the point at which it was interrupted.
If the door cannot be opened, it is possible that the temperature in the machine is too high, and you
won't be able to add the laundry.
Also, if the door cannot be opened, it is possible that the program has been running for too long and
any laundry added at that point would not be efficiently washed.
Pausing, stopping or changing the program
To pause the program, shortly press the Start/Pause button.
To resume a program, press the Start /Pause button again.
To stop the washing program, press the Start/Pause button and hold it for 3 seconds.
Choose "Stop program". The program is canceled and the water is pumped out of the machine if
necessary. Only then will you be able to open the washing machine door. Use the Program selector
knob to select a new program. If necessary, add detergent, and then press the Start /Pause button.
INFORMATION!
If the temperature in the drum is very high, then cooling procedure starts before program is
canceled.
A washing program can be paused by pressing the ON/OFF button.
The washing machine will switch off.
After the washing machine is switched on, press the Start button to resume the program.
INFORMATION!
Do not open the detergent compartment while the appliance is operating.
INFORMATION!
In some cases the door may be locked although no program is in progress (e.g. in case of an
error). To unlock the door, press the Start/Pause button and hold it for a while.
STEP 8: End of program
After the end of the washing program, the display will indicate that the program has been successfully
completed and that the door is unlocked.
Open the door towards you and remove the laundry from the washing machine.
Make sure the washing machine drum is empty.
28
To Next Page
