Allied Telesis AR Series User Manual

C613-22104-00 REV B Firewall/NAT Rules, Entities and Performance | Page 35
Configuring Anti-virus Advanced Network Protection
Configuring Anti-virus
This section provides an example of how to configure Anti-virus.
By default, Anti-virus protection is disabled and you need to explicitly enable it
.
Step 1: Enter the Antivirus mode.
awplus#configure terminal
awplus(config)#antivirus
Step 2:
Set the provider and enable Anti-virus protection.
awplus(config-antivirus)#provider kaspersky
awplus(config-antivirus)#protect
Step 3:
(Optional) Set the action to take when a scan fails.
By default, when a scan fails or when the limit is exceeded, the default action is deny (block). To
allow HTTP traffic when a scan fails, enter the command:
awplus(config-antivirus)#action scan-failed permit
Step 4:
Show the information about the operation of Anti-virus.
awplus(config-antivirus)#do show antivirus
Output 2: Example output from the console
awplus#show antivirus
Status: Enabled (Inactive Unlicensed)
Provider: Kaspersky
Scan failed action: block
Limit exceeded action: block
Resource version: not set
Resource update interval: 1 hour

Allied Telesis AR Series Specifications

General

Brand	Allied Telesis
Model	AR Series
Category	Firewall
Language	English