AT-S63 Management Software Menus User’s Guide
Section VI: Virtual LANs 477
Example of Creating a Port-based VLAN
This procedure is an example of how to create an untagged VLAN. The
specifications of the VLAN are:
Name: Sales
VID: 2
Untagged ports, 1, 3 to 5
To create this VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 171 on page 472.
2. From the VLAN Configuration menu, type 3 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 172 on page 473.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 173 on page 473.
4. From the Create VLAN menu, type 1 to select VLAN Name and enter
“Sales”.
5. Type 2 to select VLAN ID (VID) and enter “2”. This is the VID value for
the new VLAN.
6. Type 3 to toggle VLAN Type to Port Based.
Note
Option 4, Tagged Ports, is left empty because this VLAN will not
contain any tagged ports.
7. Type 5 to select Untagged Ports and enter “1,3-5”. These are the
untagged ports of the VLAN. Press Return.
Note
Option 6, Protected Ports, must be left in the “No” default setting
when creating a port-based or tagged VLAN. This option is
explained in Chapter 27, “Protected Ports VLANs” on page 521.
8. Type C to select Create VLAN.
9. When you see the confirmation prompt, press any key.
To Next Page
Loading...
