CentreCOM GS970M Series Quick Installation Guide 11
4. Go to “Ports” on page 13.
Installing the Switch on a Wall
For installation instructions for the GS970M/10 Switch and the BRKT-
J23 wall brackets, refer to the GS970M Gigabit Ethernet Switch
Series Installation Guide.
Here are the tools and material for installing switches on a wall with
the optional BRKT-J24 brackets:
BRKT-J24 brackets and sixteen screws
Four wood or concrete wall screws (not provided)
Four wall anchors for concrete walls (not provided)
Cross-head screwdriver (not provided)
Flat-head screwdriver (not provided)
Stud finder for a wooden wall, capable of identifying the middle of
wall studs and hot electrical wiring (not provided)
Drill and 1/4” carbide drill bit for a concrete wall (not provided)
Note: You can install the switch on a wall with the front panel facing
up, left, or right. Do not install it with the front panel facing down.
Warning: The device should be installed on the wall by a
qualified building contractor. Serious injury to yourself or
others or damage to the equipment may result if it is not
properly fastened to the wall. E105
To Next Page
Loading...
Need help?
General
