ALLU D SERIES - ORIGINAL INSTRUCTION MANUAL - ALLU_6-M-DENG0615
6
1.5 The content of the EC-conformity declaration
EC-conformity declaration
(2006/42/EC, Appendix II A, Directive 2000/14/EC)
The manufacturer: ALLU Finland Oy
Of the address: Jokimäentie 1, 16320 Pennala, FINLAND
Declares that Screener crusher model AAA, serial number ZZZ
conforms with the terms of the Machinery Directive (2006/42/EC)
and conforms with the terms of the Noise Emission Directive (2000/14/EC).
This conformity declaration is valid if the machine has not undergone any changes not
approved by the manufacturer in writing.
N.N., authorised to compile the technical specifications for this machine
N.N.,authorised to prepare this conformity declaration
Date: dd.mm.yy
Place: Jokimäentie 1, 16320 Pennala, FINLAND
1.6 The scope of the manual
This manual contains instructions for safety and on the use, transport, lubrication, and
maintenance of this machine in the state it was in when released from the factory.
This manual and the safety instructions, in particular, along with the EC-conformity
declaration, are valid only if changes not approved by the manufacturer have not been made
to the machine.
A different machine model may have been used for some of the manual’s illustrations, or
some covers or similar parts may have been removed to allow for clearer depiction of the
situation.
Because the product undergoes continuous improvement and development work, some
changes might have been made to it that are not reflected in this manual.
Courtesy of Machine.Market
To Next Page
Loading...