ALLU D SERIES - ORIGINAL INSTRUCTION MANUAL - ALLU_6-M-DENG0615
32
Tip the Screener crusher such that the drums can be seen from the cabin of the base
machine. Rotate the drums for approximately two minutes at low speed in both
directions, to remove any air from the hydraulic system. Keep an eye out for any
leaks.
Check the hydraulic hoses and connections for leaks and damage.
Visually check that the adapter mounting bolts are not loose.
3.4.3 Correct use
The rotation direction of the drums
(bottom upward) is designed to roll the
material inside the Screener crusher, which
helps to separate finer material. If the
material does not pass through properly or
the Screener crusher becomes blocked, tilt
the bucket or use the other rotation
direction for a short while.
The intended operating angle ranges from
0° to 45° from horizontal level in relation
to the back wall.
Check that the position range of the base
machine’s booms allows the Screener
crusher to be tilted within the operating
range presented in the picture (in some
cases, tilting to the 0° position is not
possible).
The best operation angle depends on the
material being processed. Various angles
should be tested when work is
commenced.
0°
45°
Courtesy of Machine.Market
To Next Page