ALLU D Series - Troubleshooting

ALLU D SERIES - ORIGINAL INSTRUCTION MANUAL - ALLU_6-M-DENG0615 75
10. Put the set screw and nut [1] in their
places loosely, but do not tighten them
before the drums have been adjusted.
11. Fix the lubricant output connector [2]
and hex plugs [3] in their places, using
thread sealant.
4.4 Troubleshooting
WARNING
Before inspecting, opening, or attaching hose connections
or performing inspection of moving components, turn off
the base machine and depressurise the hydraulic system by
moving the control lever of the auxiliary hydraulic system
with only the starter motor turned on.Under no
circumstances place your hands between rotating parts
while the Screen crusher is attached to the base machine.
Exposure to high-pressure oil spray or getting caught
between rotating parts causes a risk of death or serious
injury.
Take the appropriate precautions when inspecting the
machine in a danger zone!
CAUTION
Minimise the risk of hydraulic oil entering the environment by having
basins and material for absorbing any leaks available while connecting the
hydraulic system and performing inspections!
1
2
3
Courtesy of Machine.Market