ALLU D Series - Replacement of Counter Blades; Drums)

ALLU D SERIES - ORIGINAL INSTRUCTION MANUAL - ALLU_6-M-DENG0615 44
Hit the cotter pin back into its place with
the cotter press. Check that the cotter pin is
centred on the blade-holder.
4.3.2 Replacement of counter blades (DN, DS, and DH models with XHD and X
drums)
Number Item Quantit
y
Note
1 Hexagonal screw M16 × 70, 10.9 2 200 Nm
2 Base plate M16 4
3 Locking nut M16 2
4 Counter blade 2
5 Counter blade lock plate 1
NOTE
Replace the counter blades regularly, to prevent the material processed
from causing wear to the frame’s counter blade-holders. At the latest, the
counter blades should be replaced when their surface is at the same level
as the upper surface of the counter-blade-holders.
Courtesy of Machine.Market