ALLU D Series - Page 73

To Next Page

To Previous Page

ALLU D SERIES - ORIGINAL INSTRUCTION MANUAL - ALLU_6-M-DENG0615

1. Loosen the set screw and its locking

nut.

2. Loosen the bearing unit’s cap by

turning it.

3. Remove the radial shaft seal from the

cap.

Courtesy of Machine.Market

Main Page

Table of Contents2
General Information5
The Purpose of the Instructions5
Identification6
Manufacturer6
CE Marking and Conformity Declaration6
The Content of the EC-Conformity Declaration7
The Scope of the Manual7
The Screener Crusher Models Covered by this Manual8
Copying8
Safety and the Environment9
Safety Notations9
Explanations for Symbols10
Safety Markings on the Screener Crusher11
Danger Zones and Exposure to Dangers During Work12
Danger Zone I (5 M)12
Danger Zone II (20 M)13
Exposure to Dangers in Connection with Transport and Maintenance14
The Screener Crusher Tipping over or Falling14
High-Pressure Spray14
Unintentional Start-Up15
Environmental Damage15
User Responsibilities and General Safety Instructions16
Intended Use and Operating Environment17
Intended Use17
Operation Range17
Unanticipated and Incorrect Use18
Repairs and Changes18
Entry into Service and Use19
Transport, Lifting, and Storage19
Transport19
Lifting and Transfer19
Long-Term Storage21
Attachment to the Base Machine21
Mechanical Attachment and Adapters21
Diagrams of Adapters24
Attachment to the Base Machine25
Connection of the Hydraulic System and Requirements for the System25
New Users and Procedures before Use31
Inspection Upon Receipt31
Use and Operation32
The Principle of Operation of the Screener Crusher32
The First Start-Up and Commissioning32
Correct Use33
Forbidden Work Methods35
Maintenance37
Maintenance Work in Connection with Use38
Daily Inspection (8 Hrs)39
Weekly Inspection (40 Hrs)39
Extensive Maintenance41
Replacement of Wear Parts43
Replacement of Blades (DN, DS, and DH Models with XHD Drums)43
Replacement of Counter Blades45
Drums)45
Replacement of Fine Screening Blades (DNS, DSB, and DHB Models)47
Replacement of Wear Parts in TS Models and Changing of the End-Product Size50
Replacement of TS Blades53
Replacement of the Bearing-Protection Fender61
Replacement of Drums63
Removal and Installation of Bearings and Chain Wheels69
Maintenance of the Bearing Unit72
Troubleshooting76
Disposal79
Technical Description80
Mounting Dimensions80
Technical Specifications82
Hydraulic Schematics85
Connecting the Screener Crusher with the Base Machine's Hydraulic System85
Single-Motor Buckets86
Two-Motor Buckets87
Noise Level89

ALLU D Series - Page 73

Table of Contents