HP 5 OPERATOR’S MANUAL
SERVICE SAFETY
PRACTICE SAFE MAINTENANCE
Keep service area clean and dry. Remove
any buildup of grease, oil, or debris.
Never lubricate or service machine while it is
running. Keep your machine in prope
working condition. Fix any damage
immediately. Replace worn or broken parts.
Unauthorized modifications to the machine
may impair the function and/or safety and
affect machine life.
PREVENT MACHINE RUNAWAY
void possible injury or death from a
machine runaway. Do not start engine by
shorting across starter terminals. The
machine will start out of neutral if normal
circuitry is bypassed. Only start the
machine from the operator’s seat with the
ground drive in neutral, clutch and threshing
cylinder off, and brake on.
RETORQUE WHEEL NUTS
Retorque machine wheel nuts and bolts
after 50 hours of operation. Failure to do so
could cause a wheel to fall off during
operation, causing the machine to tip over.
This will cause severe injury to the operato
and extensive damage to the machine.
SUPPORT MACHINE PROPERLY
lways lower the header to the ground
before working on the machine. If you must
work on head in a raised position, install the
safety locks or jack stands.
Do not work under the machine unless
ro
erl
su
orted b
the wheels or a
ack.
B-8 SAFETY
To Next Page
Loading...