HP 5 OPERATOR’S MANUAL
Bearing failure Replace bearings
Loose impeller blade Replace impeller
Bearing failure Replace bearing
Blower makes unusual noise
Impeller rubbing on housing Adjust shaft position or replace
bad impeller
ENGINE
Ground drive not in neutral Position lever in neutral
Clutch switch is on Turn off clutch switch
Parking brake is off Turn brake switch on
Dead battery Charge battery or replace
Faulty ignition switch Replace ignition switch
Faulty starter Replace starter
Faulty neutral safety switch Replace switch
Engine does not turn over
Bad starter relay Replace relay
Air in fuel Check fuel lines / fittings bleed
as necessary
Check / replace engine fuel
pump
Check fuel shut off solenoid
Engine turns over but fails to
start
Not getting fuel
Check fuel inline filter
Water in fuel Change fuel filter Engine starts, but runs rough
or kills often
Plugged air cleaner Clean air cleaner
GROUND DRIVE
Fail-safe (parking) brakes
engaged
Disengage parking brake
Fail-safe (parking) brakes on Check charge pressure, Speed
up engine
Hand control cable binding or
broken, worn cable ends
Lube cable, ends. Replace worn
parts
Component failure Contact ALMACO
Combine will not move
Insufficient charge pressure Contact ALMACO
If the problem does not appear in this section or if there are any questions on how to
proceed with a solution contact ALMACO.
D-6 TROUBLESHOOTING
To Next Page
Loading...