Appendix C: Swirl X Flow Conditioner for TSI Model 8375 ACCUBALANCE
®
Air Capture Hood 69
Installation and Usage
1. Put the two pieces together and place it in the base as shown below (it will sit on top of the flange of
the base).
2. Install the support rods and 2’ x 2’ (610 mm x 610 mm) frame/fabric.
3. When set up, use hood as normal. There is no need to change K-factors or access any special
menus for use.
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
