Need help?Do you have a question about the Alpha-InnoTec WZS Series and is the answer not in the manual?
General| Brand | Alpha-InnoTec |
|---|---|
| Model | WZS Series |
| Category | Heat Pump |
| Language | English |
Essential preliminary information for unit operation and handling.
Explanation of symbols employed throughout the operating manual.
Covers electrical hazards, high voltage, and fatal injury risks.
Addresses refrigerant dangers and the need for qualified technicians.
Instructions to observe safety labels on and within the unit.
Potential risks associated with leaking refrigerant.
Explanation of how heat pumps function.
Information on heat quantity recording (HQR) requirements.
Guidance on efficient operation and energy-saving practices.
Using the room thermostat to control the cooling function.
Conditions required for activating the cooling function.
Instructions for cleaning the exterior surfaces of the unit.
Procedures for regular inspection and maintenance of unit components.
Procedures for cleaning and rinsing unit components.
Information on detecting and resolving unit malfunctions.
Important notices and warnings for proper unit installation.
Emphasis on installation by qualified technicians only.
Specifications for the indoor installation area.
General safety measures during installation.
Adherence to required clearance dimensions for installation.
Specific precautions for installing the module box.
Designing the heat source system according to standards.
Ensuring adequate pipe dimensions and flow rates.
Procedure for rinsing the condenser.
Preventing damage by securing connections during work.
Noting inflow and outflow connections and their markings.
Installing vibration decouplers for units without cooling.
Installing vibration decouplers for units with cooling.
Securing connections against twisting when tightening.
Avoiding exceeding specified operating pressures.
Covers electrical safety dangers and regulatory compliance.
Procedures for preparing and installing wires.
Ensuring electric cabinet safety during rinsing operations.
Procedures for cleaning components by authorized personnel.
Checking the concentration of anti-freeze in the mixture.
Connecting the safety valve drain pipe before rinsing.
Ensuring correct seating of the 3-way valve motor.
Checking electrical conductivity of hot water outflow.
Connecting safety valve drain pipe for hot water tank.
Procedure for bleeding the heating circuit pump.
Steps for bleeding the module box.
Insulating connections according to local standards.
Steps for inspecting and setting up the overflow valve.
Procedure for adjusting the overflow valve's temperature difference.
Safety warnings regarding electrical connections for the control element.
Step-by-step guide for installing the unit screen.
Step-by-step guide for removing the unit screen.
Requirement for floor heating approval for cooling use.
Guidelines for installing the room thermostat.
Adherence to applicable local standards and directives.
Information on the built-in safety temperature limiter.
Steps for safely removing the module box from the unit.
Procedure for removing the buffer battery from the processor board.
List of heat pump models covered by the declaration.
List of relevant EC directives the device complies with.
Compliance with national standards and directives.
List of standardized EN norms the device adheres to.
A checklist for installation and assembly personnel.
Specifying whether initial or repeat commissioning is requested.
Selection of specific commissioning options and services.
To Next Page