Chapter 5 Parameter Introductions
http://www.acdrive-china.com
189
Fig. 5-15-2 Flow chart of user password unlocking
PF.04 G/P selection
Range: 0,1【
0
】
0: Type G (Constant torque) 1: Type P (Inlet fan and pump series loads)
Note:
◆The parameter is only valid to the ac drive of G/P series, otherwise it is always 0.
◆Default value of the ac drive is 0. If want type P, please setting PF.04 to 1.
Example: When the ac drive model is type G (such as 31R5GB), you want the ac drive
of 32R2PB (Type P), set
PF.04 to 1.
Tips: By this way, you can get a type G ac drive from a type P ac drive.
To Next Page
Loading...
