Alpine CDA-118M - Device Error Indicators; iPod Mode Error Indications; USB Memory Error Indications

42-EN
• Abnormal current is run to the USB connector device.
- You can solve the problem by switching the source, turning the
unit power off, or ACC to the OFF position.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• An iPhone/iPod is not connected.
- Make sure the iPhone/iPod is correctly connected and the cable
is not excessively bent.
• There are no songs in the iPhone/iPod.
- Download songs to the iPhone/iPod and connect to this unit.
• Communication error
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPhone/iPod
and this unit, using the iPod cable.
• Caused by the iPhone/iPod Software Version not being
compatible with this unit.
- Update the iPhone/iPod Software Version to be compatible
with this unit.
• The iPhone/iPod is not verified.
- Change another iPhone/iPod.
• Abnormal current is run to the USB connector device.
- You can solve the problem by switching the source, turning the
unit power off, or ACC to the OFF position.
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
• Communication error
- Turn the ignition key OFF, and then set to ON again.
Indication for iPod Mode
CURRENT
ERROR
DEVICE
ERROR
NO USB
DEVICE
3
Indication for USB memory
CURRENT
ERROR
DEVICE
ERROR
NO USB
DEVICE
UNSUPORT