Alpine INE-NAV-30 - Elements of the Active Route; Traffic Events

18
2.2.3.7 Elements of the active route
Your software shows the route in the following way:
Symbol
Name
Description
Current GPS position and Start
point
Your current position displayed on the map. If roads are
near, it is aligned to the nearest road.
Normally if GPS position is available, the route starts
from the current position. If there is no valid
GPS
position, your software uses the last known position
as
the start point.
Waypoint (intermediate
destination)
An intermediate destination of the route
before reaching
the final destination.
Destination (end point) The final destination of the route.
Route color
The route always stands out with its color
on the map,
both in daytime and in night color mode.
Streets and roads that are
excluded from the navigation
You can choose whether you want to use or avoid
certain road types (page 74). However, when your
software cannot avoid such roads, the route will include
them and it will show them in a color that is different
from the route color.
Streets and roads that are
affected by traffic events
Road segments may be affected by traffic events
received. These streets and roads are displayed in an
alternate color, and small symbols displayed along the
route show the type of the
traffic event
.
2.2.3.8 Traffic events
Road segments affected by traffic events are displayed with an alternate color on the map, and small
symbols above the road show the nature of the event:
Tap to open the list of traffic event categories: