Installation
INE-Z928HD/INE-NAV-38 users
To
install
the
INE-Z928HD/INE-NAV-38, refer
to
the
manual
in
the
separately purchased installation kit
for
each car
type.
•
When
making
connections
to
the vehicle's electrical
system, be aware
of
the factory installed components
(e.g.
on-board computer). Do
not
tap into these leads
to
provide power
for
this unit.
When
connecting the INE-
S920HD/INE-NAV-30/INE-Z928HD/INE-NAV-38
to
the fuse box,
make
sure the fuse for the intended circuit
of
the INE-S920HDIINE-NAV-30/INE-Z928HDIINE-
NAV-38 has the appropriate amperage. Failure
to
do
so
may
result in damage
to
the
unit
and/or the vehicle.
When
in doubt, consult
your
Alpine dealer.
• The Display
must
be completely retracted in the casing
when installing.
If it
is
not, problems
may
occur.
1 Before installing, make sure
that
the
opening and closing
of
the
display will not
interfere with operation
of
the
gear shift.
(INE-Z928HD/INE-NAV-38 Only)
2
12-EN
Movable
Display
Install
at
an angle between horizontal
and 30°. Note
that
installing at an angle
outside
of
this range will result in a
loss
of
performance and possibly damage.
II
..
,.,'
I
II
'
II
1,'
I
~)
, I
I
'
I
3
Installation
Mounting
the
Microphone.
For
safe
use,
make sure
of
the following:
• location
is
stable and firm.
• driver's view and operations
are
not
obstructed.
• microphone
is
located where the driver's voice
can
be easily picked up (on the sun visor, etc.).
When you speak into the microphone, you should
not
have
to
change your driving posture. This may
cause a distraction, taking your attention away
from safely driving your vehicle. Carefully consider
direction and distance while
mounting
the
microphone. Confirm that the driver's voice can be
easily picked
up
at the selected location.
Microphone
4 Remove
the
mounting sleeve from
the
main unit.
This unit
Bracket keys
r..~
(Included)
Slide
the
unit into
the
mounting sleeve and
secure it.
To Next Page
Loading...
