Alpine PXE-R600 - Wire Controller Operation; Boot Screen and Volume; Source and Mix Selection; Subwoofer and Preset Control

13
Instructions for Wire Controller
The PXE-R600 device can be tuned and set by the
RUX-C600 wire controller. Please connect the wire
controller correctly to the device before using and make
sure it starts normally.
Note: Wire controller and tuning software cannot be
used simultaneously.
Boot Screen
After the wire controller is started, the dynamic boot
screen is displayed, as shown in Figure 1.
VOLUME
After startup, enter the main interface of the wire
controller - VOLUME interface, as shown in Figure
2-1. The master volume can be adjusted by turning
the knob. Turn clockwise to increase the volume
and counterclockwise to decrease the volume. The
adjustment range is 0~35. Short press the knob on
the VOLUME interface to enter the MUTE interface, as
shown in Figure 2-2.
MAIN SOURCE
On the main interface, long press the knob for 2-5
seconds to enter the MAIN SOURCE interface, as
shown in Figure 3. Turn the knob to select the main
sound source: high level (Hi.L), Bluetooth (BT), low
level (AUX). When Bluetooth and high level or low level
signal are connected at the same time, Bluetooth will be
set as the main sound source directly by default. After
no operation for about 5 seconds, it will automatically
exit this interface and return to the main interface of the
wire controller (VOLUME interface).
MIX SOURCE
On the MAIN SOURCE interface, short press the
knob to enter the MIXSOURCE interface, as shown in
Figure 4-1. Turn the knob to select the auxilliary sound
source: high level(Hi.L), Bluetooth (BT), low level
(AUX), turn o󰀨. After no operation for about 5 seconds,
it will automatically exit this interface and return to
the main interface of the wire controller (VOLUME
interface).
SUBW
On the MIX SOURCE interface, short press the knob
to enter the bass volume adjustment interface (SUB
W), as shown in Figure 5. The SUBW of the device can
be adjusted by turning the knob of wire controller. Turn
clockwise to increase the SUBW and counterclockwise
to decrease the SUBW. The adjustment range is
0~15. After no operation for about 5 seconds, it will
automatically exit this interface and return to the main
interface of the wire controller (VOLUME interface).
PRESET
Short press the knob on the SUBW interface to enter
the PRESET interface, as shown in Figure 6-1. Among
it, the number after PRESET represents the sound
e󰀨ect data called by the current device.
Select the required sound e󰀨ect data by turning the
knob. When moving the cursor to the corresponding
number, short press the knob to call directly, as
shown in Figure 6-2. After completion of the call, it will
automatically exit this interface and return to the main
interface of the wire controller (VOLUME interface).
Figure 6-2
Figure 1
Figure 2-1 Figure 2-2
Figure 3
Figure 4-1
Figure 5
Figure 6-1
Figure 4-2