5. Add the Water Pump Handle to the Fountain Top
by inserting the handle shaft into the center of the
Fountain Top. Then line up the handle and insert
the Bolt through the handle pivot point. Tighten
the nut.
6. Gently pour water into the fountain basin, being
careful not to overflow and cause splashing. Make
sure the water completely submerges the pump
and the water runs clear during operation.
NOTE: We recommend that you use distilled water
to prevent scale build-up. The first time you operate the
pump it can take up to 5 minutes for the air to be
completely expelled and water begins to flow properly
7. Plug the pump cord into your local power supply.
Make sure that there is no water around the plug
& always keep the power source in a dry place.
8. Now adjust the water pump to your flow
preference. (see Quick Tip #1) Add the included
Rocks to the Pail of the Fountain.
9. Congratulations, your fountain is now complete.
Don’t forget to add water regularly as water will
evaporate over time.
Relax and enjoy your new fountain
To Next Page
Loading...
