Unpack all components carefully. Please check to
ensure all parts have been removed from the
packaging. *Some splashing may occur
when the
product is in use.
1. Place the Fountain Base on a smooth and level
surface. Allow enough space to access the pump.
3. Now mount the Fountain Top to the Fountain Base.
The Fountain Top hose will slide through the hole
in the top of the Fountain base. Use the alignment
notch on the rear of each piece for a proper fit.
If you have any questions and/or problems, please
contact the retail store you purchased this fountain.
• If your pump fails to run
• Check the circuit breaker or try a different
outlet to make sure the pump is receiving
electrical power.
• Check the pump discharge and tubing for
any kinks and/or obstructions
• Any buildup obstructing the water flow can
be flushed with a garden hose
• Check the rotor by removing the front cover
& plate to access the impeller area. Turn
the rotor and make sure that the rotor is not
jammed or broken
• If your pump “spews”
• Check the water level to make sure the
pump is completely submerged and there is
enough water in the basin to operate your
fountain. Not having enough water will
cause your pump to spew
• If your pump is making abnormal loud noises
• Disconnect the pump from the electrical
power supply and remove the front cover &
plate
• Carefully grip the impeller and gently pull the
impeller/rotor assembly out of the pump
housing
• Rinse the impeller/rotor assembly and clean
the cavity with clean water. If breakage or
damage is found, contact your local retailer
for parts.
ASSEMBLING & USING YOUR PRODUCT
To Next Page
Loading...
