HYC200 – Installation and Maintenance Manual
Version 1-1
6 Mechanical and electrical installation
All rights reserved. Reproduction of this document, even in part, is only permitted with the approval of Alpitronic Srl.
Fasten the cable lugs of the grid cables directly to the busbars or brass sleeves using a
standard M12 washer (DIN125), a contact washer and an M12 screw.
Notice
Tighten the screws with a torque of 35 Nm.
Figure 56: Fastening the cable lugs
After connecting the grid cables, be sure to attach the appropriate
plexiglass covers.
To Next Page
