Alpitronic Hypercharger HYC 150 User Manual

hypercharger - Operation Instructions and Installation Guide
Version 2-2
Hardware
Content
All rights reserved. The reproduction of this document, also partially, is allowed only with authorization by alpitronic Srl
Operation Instructions and
Installation Guide - Hardware
hypercharger HYC_150 / HYC_300
(75 kW – 300 kW)
ultra-fast charging system for electric vehicles
for HW-Versions 4

Alpitronic Hypercharger HYC 150 Specifications

General

Power Output	150 kW
Charging Standards	CCS, CHAdeMO
Input Voltage	400 V AC
Cooling System	Liquid cooling
Efficiency	>95%
Ingress Protection	IP54
Number of Charging Points	2
Protection Features	Overvoltage, Overcurrent, Short-circuit
Communication Interface	Ethernet
Operating Temperature	-30°C to +50°C
Communication	Ethernet, 4G
Output Voltage	150-1000 VDC

Summary

Safety Instructions

Designated Use

Describes the intended use and environmental conditions for the hypercharger system.

User Guidelines

Defines the target audience and their required knowledge for safe operation.

Installation and Maintenance Safety

Critical safety precautions for installation, service, and repair activities on the hypercharger.

Product Description

Installation and Commissioning

Mechanical Installation

Electrical Installation

Checks Before Initial Startup

Commissioning Protocol

Operating the Hypercharger

Start Charging Session

Guides users through authentication, plug selection, and connecting the vehicle.

During the Charging Process

Information on monitoring the charging status, power, and battery state.

Terminate Charging Session

Procedures for safely stopping a charging session and disconnecting the vehicle.

Procedure for Error Messages

Guidance on identifying and resolving common error messages encountered during operation.

Maintenance

Repair and Service

Technical Specifications