hypercharger - Operation Instructions and Installation Guide
Hardware
Version 2-2
All rights reserved. The reproduction of this document, also partially, is allowed only with authorization by alpitronic Srl
1. Safety instructions
This chapter contains the safety instruction which must be considered at installation,
operation and maintenance of the hypercharger ultra-fast charging system for electric
vehicles. Incorrect operation as a result of non-compliance with the operation instructions
may lead to severe injuries or damages. This safety operation must be read carefully before
the installation, operation and maintenance of the hypercharger ultra-fast charging system.
1.1. Designated use
The hypercharger ultra-fast charging system for electric vehicles is intended to be used both
in indoor and outdoor environments for performing ultra-fast charging for electric vehicles.
Attention
The charging station is designed for a stationary installation in an
ambient with pollution degree class 3.
For the connection between the electric vehicle supply equipment
(EVSE) and electric vehicle (EV), no additional cables are required
besides the AC cable, which needs to be in possess of the user. A
charging cord shall not be altered to extend or divide the cable length.
No adapters may be used which are not explicitly approved by the
vehicle manufacturer.
The use of Y-cables or similar devices is not permitted.
No cable extensions may be used.
National application guidelines and specifications for charging stations
must be taken into account.
1.2. Users
These operation instructions and installation guides are intended for the operators
responsible for installation, operation, service and maintenance of the hypercharger ultra-
fast charging system for electric vehicles. These operators should have an in-depth
knowledge of electrical high-power systems and electric vehicles. Prior to carrying out any
work the operator and the responsible technical personnel must carefully read these
instructions.