HYC200 – Installation and Maintenance Manual
Version 1-1
6 Mechanical and electrical installation
All rights reserved. Reproduction of this document, even in part, is only permitted with the approval of Alpitronic Srl.
6.8. Final steps
Finally, reinstall the cooling unit if present. Fasten them and connect the connector and the
cooling hoses.
Close all doors properly again.
Unpack the charging cables and insert them into the corresponding cable plug holders.
In addition, the crane eyelets should be removed and the locking screws, which are included
in the scope of delivery, should be attached.
To Next Page
