End of equipment service life
Dismantling and recovery of components
from a circuit breaker
P80--0001EN/02
2/6
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
I -- Introduction
During the elimination phase for a High Voltage gas insulated circuit
breaker, at the end of its service life, the quality of the treatment of wastes
generated represents the essential environmental aspect.
This manual proposes, for each element of a High V oltage gas insulated
circuit breaker, the recommended method of elimination for the various
materials it comprises, as well as any possible precautions to be taken.
To Next Page
Loading...
Need help?
General
