End of equipment service life
Dismantling and recovery of components
from a circuit breaker
P80--0001EN/02
3/6
01--2011
© ALSTOM 2010. All rights reserved. Information contained in this document is indicative only. No representation or warranty is given or should be
relied on that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is
provided without liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is
strictly prohibited.
GRID
II -- General remarks
It is necessary to proceed with a maximum amount of dismantling, so as to
ensure the best recycling possible of the materials.
Various categories of materials can be distinguished depending on the
waste processing channel followed:
S The SF6 gas to be recycled or reprocessed
S The metals to be recycled (without taking into account any surface
treatment, paintwork or electro--silverplating)
S W aste products to be destroyed by incineration or sent to the waste
dump depending on the channel available.
S Special wastes
To Next Page
Loading...
Need help?
General
