14
NOTE You can personalize the EQ presets by selecting a Preset EQ then
pressing the “EQ” button twice to enter the Bass/Treble Control Mode.
There you can make adjustments to the Preset EQs as described in the
Bass and Treble Control sections. Changes are saved automatically.
NOTE: To reset the EQ Presets to factory settings, press and hold the EQ
button for a few seconds.
How to Adjust the 7-Band Graphic EQ Using the Onboard Controls
For even greater personalization of your music, you can dial in your sound
with the onboard 7-band graphic EQ.
1 Enter the Graphic EQ Mode.
Press and hold the “EQ” button while you press the
or buttons.
2 Select a frequency slider for adjustment.
Press the
or buttons until the desired slider is highlighted.
3 Increase or decrease the level of the frequency slider.
Rotate the
knob.
4 Select the next frequency slider for adjustment.
Press the
or buttons until the next desired slider is highlighted.
5 Increase or decrease the level of the frequency slider.
Rotate the
knob.
6 Continue selecting and adjusting frequency sliders as desired.
7 Exit the Graphic EQ Mode.
Press the “EQ” button again. Or the unit will automatically exit this
mode after several seconds.
NOTE: To reset the Graphic EQ to factory settings, press and hold the “EQ”
button for a few seconds.
How to Adjust the 7-Band Graphic EQ Using the Clip-On Remote
1 Enter the Graphic EQ Mode.
On the speaker system, press and hold the “EQ” button while you
press the
or buttons.
2 Select a frequency slider to adjust.
Press the
or buttons on the clip-on remote until the desired slider
is highlighted.
3 Increase or decrease the level of the frequency slider.
Press the + or “–” buttons on the clip-on remote.
4 Select the next frequency slider to adjust.
Press the
or buttons on the clip-on remote until the next desired
slider is highlighted.
5 Increase or decrease the level of the frequency slider.
Press the “+” or “–” buttons on the clip-on remote.
6 Continue selecting and adjusting frequency sliders as desired.
7 Exit the Graphic EQ Mode.
Press the “EQ” button on either the clip-on remote or the speaker
system. Or the unit will automatically exit this mode after several
seconds.
NOTE: To reset the Graphic EQ to factory settings, press and hold the “EQ”
button for a few seconds.
Setting EQ Controls
To Next Page
Loading...
