Altec Lansing IMT800 - Setting EQ Controls; Bass, Treble, and EQ Presets

13
EN
Setting EQ Controls
How to Set the Bass and Treble Control Using the Onboard Controls
1 Access the bass and treble settings.
Press the “EQ” button once. The Bass Control screen will appear on
the LCD.
2 Increase or decrease the bass level.
Rotate the
knob.
3 Enter the Treble Control screen.
Press the EQ button again. The Treble Control screen will appear.
4 Increase or decrease the treble level.
Rotate the
knob.
5 Exit the Treble Control screen.
Press the “EQ” button again. Or the unit will automatically exit this
screen after a few seconds.
How to Set the Bass and Treble Control Using the Clip-On Remote
1 Access the bass and treble settings.
Press the “EQ” button once. The Bass Control screen will appear on
the LCD.
2 Increase or decrease the bass level.
Press the “+” or “–” buttons.
3 Enter the Treble Control screen.
Press the “EQ” button again. The Treble Control screen will appear.
4 Increase or decrease the treble level
Press the “+” or “–” buttons.
5 Exit the Treble Control screen.
Press the “EQ” button again. Or the unit will automatically exit this
screen after a few seconds.
How to Change the EQ Presets Using the Onboard Controls
1 Access the EQ presets.
Press and hold the “EQ” button for approximately 3 seconds.
2 Select your desired preset.
Press the
or buttons to cycle through the four EQ presets.
Presets include: 1) ALTEC EQ, 2) ROCK, 3) HIP HOP, and 4) POP.
3 Exit the EQ Preset screen.
Press the “EQ” button again. Or the unit will automatically exit this
screen after a few seconds.
NOTE: To reset the EQ Presets to factory settings, press and hold the EQ
button for a few seconds.
How to Change the EQ Presets Using the Clip-On Remote
1 Access the EQ presets.
Press and hold the “EQ” button for approximately 3 seconds.
2 Select your desired preset.
Press the
or buttons to cycle through the four EQ presets.
Presets include: 1) ALTEC EQ, 2) ROCK, 3) HIP HOP, and 4) POP. Or,
press P1 for ALTEC EQ, P2 for ROCK, P3 for HIP HOP or P4 for POP.
3 Exit the EQ Preset screen.
Press the “EQ” button again. Or the unit will automatically exit this
screen after a few seconds.