15 (48)
CONTROL PANEL
OPERATING AC FROM THE CONTROL PANEL
The control panel is on the top of the AC, it enables you to manage part functions without remote controller, but to fully
exploit its potential, you must use the remote controller.
TURNING THE AC ON:
1. Plug into the mains socket. The AC will turn on in standby mode.
2. Turn on the AC by pressing . The last function agive when the AC was turned off will appear.
3. Turn off the AC by pressing .
4. Wait a few minutes before unplugging.
Important! Never turn the AC off by unplugging from the mains without following above instructions first. By following
the instruction the AC is allowed to perfrom a cycle of checks to verify operation.
To Next Page
Loading...
Need help?
General