17 (48)
Programming shutdown
1. When the AC is started press
. The Timer mode indicator and number of hours on the display starts to flash.
2. Press or to set the number of hours delay before the AC shut downs. The Timer mode can be set in intervals of
0.5 hours up to 10 hours, or intervals of 1 hour up to 24 hours.
3. A few seconds after set, the setting is memorized, the Timer mode indicator is lit and the display shows the current
mode. At the end of the set time the unit automatically turns to standby mode.
4. To end Timer mode: press again or . The symbol disappears from the display.
SELF-DIAGNOSIS
The AC has a self diagnosis system to identify a number of malfunctions. Error messages are shown on the display..
Fault code Solution
Low temperature (frost prevention)
The AC is fitted with a frost protection device to avoid
excessive formation of ice.
The AC starts up again automatically when the defrosting
process is completed.
Probe failure (sensor damaged)
lf this is displayed, contact your local authorised service
centre.
Full tank (safety tank full)
Empty the internal safety tank, following the instructions in
the "End of season operations" paragraph.
To Next Page
Loading...
Need help?
General