To Next PageTo Next Page
What to do if Alto-Shaam 1200-TH/III Oven display is lit but not heating (Error Code E30)?
If your Alto-Shaam oven's display is lit, and the unit calls for heat but isn't heating, and shows Error Code E30, check the high limit switch at the rear of the unit. If tripped, reset it by pressing the high limit reset button. If it resets, address the cause of the trip. If the switch won't reset, it's defective and needs replacement.
How to troubleshoot no power and a dark display on my Alto-Shaam Oven?
If your Alto-Shaam Oven display isn't lighting up, start by verifying that the outlet or junction box has power. Then, check if the circuit breaker switch on the back of the unit is turned on. Also, ensure the power cord isn't faulty by checking its continuity with a VOM meter. If these steps don't solve the issue, further troubleshooting involving the unit's internal components is needed, such as testing for power at the load side of the circuit breaker and replacing it if necessary, or testing the load side and replacing the filter if needed.
Why is my Alto-Shaam 1200-TH/III Oven under temperature?
Your Alto-Shaam oven might be under temperature due to several reasons. Check if the oven door is completely closed and whether the door gasket needs replacement. Ensure you haven't skipped preheating and that the oven isn't overloaded, especially with frozen products. Other potential causes include a defective air sensor or probe, a defective solid-state relay, bad wire connections, an open heating cable, or a tripped high limit switch. If none of these issues are present, it is advised to call for service.
What to do if my Alto-Shaam 1200-TH/III is over temperature?
If your Alto-Shaam oven is experiencing over temperature issues, the cause might be a shorted cable, a defective solid state relay, or a defective air sensor. If none of these issues are present, it is advised to call for service.
How to fix Real time clock error in Alto-Shaam Oven?
To fix a real time clock error in your Alto-Shaam oven, the control must be replaced. If the appliance has been unplugged for an extended period, the Real Time Clock may require recharging. Plug the unit into the proper receptacle for a minimum of 24 hours.
How to resolve a Configuration connector error on Alto-Shaam Oven?
To resolve a configuration connector error on your Alto-Shaam oven, first check the control connections for any loose wires. If you find none, the control must be replaced.
How to fix EEPROM Function data error in Alto-Shaam Oven?
To fix an EEPROM Function data error in your Alto-Shaam oven, replace the control.
What to do for EEPROM Calibration data error in Alto-Shaam Oven?
If you are experiencing an EEPROM Calibration data error with your Alto-Shaam oven, the suggested solution is to replace the control.
How to resolve EEPROM Unit ID error on Alto-Shaam 1200-TH/III?
To resolve an EEPROM Unit ID error on your Alto-Shaam oven, you need to replace the control.
General| Model | 1200-TH/III |
|---|---|
| Category | Oven |
| Brand | Alto-Shaam |
| Capacity | 12 pans |
| Power Supply | Electrical |
