EasyManua.ls Logo

Alto-Shaam 1200-TH/III

Alto-Shaam 1200-TH/III
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
#8311 O&C MANUAL TH/III FAMILY
PG. 10
SECTION 2 CONTROL OPERATION SECTION 2
ON/OFF
START
Cook by Probe: IS THE MAIN ELECTRICAL POWER SWITCH ON?
Press and release control ON/OFF Key.
The green indicator light on the ON/OFF key will illuminate.
The oven will beep for one second.
The oven will begin operating in the hold mode.
The amber hold indicator will illuminate.
The previously set hold temperature will be displayed.
Press the HOLD Key.
To change the hold temperature, press the UP or DOWN ARROW Keys.
Note: If the oven is being used for hot food holding only, adjust the set holding
temperature. Do not press the COOK, TIME, or PROBE keys.
Press COOK Key to preheat.
The green indicator light on the COOK Key will illuminate.
Last set cooking temperature will be displayed.
To change the cook temperature, press the UP or DOWN ARROW Keys.
The green indicator light on the T
IME Key and on the PROBE Key alternately flash.
Press PROBE Key.
The green indicator light on the PROBE Key will illuminate.
Last set internal product temperature is displayed.
To change the internal product temperature, press the UP or DOWN ARROW Keys.
The green indicator light on the PROBE Key will illuminate.
Halo Heat and Pre-Heat indicator will illuminate.
The oven is automatically programmed to preheat to the cook temperature.
The oven will beep when preheated and the preheat indicator extinguished.
Both the Ready and Start indicator lights will flash.
The set cook temperature will be maintained by the oven and appear in the display
while in the ready/start mode.
Load the food inside oven. Remove probe from its bracket, wipe the probe tip
with a disposable alcohol pad and insert probe properly into the product. Close
the oven door.
Note: Oven will beep 3 times every 25 seconds until oven is loaded and START Key pressed.
Press and release START key.
COOK
The oven will beep.
The green indicators for power, cook, probe, and start will illuminate.
The display will alternate between showing the probe temperature and the elapsed time.
HOLD
The oven will beep when the set probe temperature has been reached.
The green indicator for cook will remain illuminated.
The display will alternate between showing the set hold temperature and the amount of time
the product has remained in the holding mode.
Ready indicator light will illuminate after 2 hours in the hold mode.
Note: The ready indicator does not necessarily indicate a product-ready state. For best
results, the product must remain in the oven at the set holding temperature for the
minimum number of hours indicated in the individual cooking instructions.
The oven will remain operating in the hold mode until the control ON/OFF Key is pressed.
Cold food for
rethermalization
or reheating
must never be
added to the
oven
while hot food is
being held.

Other manuals for Alto-Shaam 1200-TH/III

Related product manuals