WHEN MOUNTING DRIP TRAY,
SEAL DRIP TRAY HOLDER TO
UNIT WITH AN R.T.V. SEALANT
DRIP TRAY
DRIP TRAY HOLDER
OPTIONAL DRIP TRAY MOUNTING INSTRUCTIONS
MODELS:
W164 N9221 Water Street • P. O. Box 450
Menomonee Falls, Wisconsin 53052-0450
EXTERNAL DRIP TRAY PACKAGE: #4018
500-S OPTIONAL
For on-site installation of the external drip tray, it is
necessary to drill and tap 3 holes in the cabinet as
shown on the above drawing. Use a 8 — 32 tap, 1/8" drill bit or #30 bit.
[Bottom of oven interior • Below side-racks]
OPTIONAL DRIP PAN
®
3: 8 — 32 x 1/2" SCREWS
[A/S PN: SC-2425]
To Next Page
Loading...
