Rear panel
3. CONTROL ELEMENTS
SPOTLIGHT
8
a. IEC SOCKET FOR AC POWER CABLE (For MISTRAL 2500/4000)
Connect the supplied main cord. Do not insert the power cord into the MISTRAL
stereo power amplifier and into the AC Outlet until voltage has been correctly
set.
b. POWER CORD (Only for MISTRAL 6000)
This is an IEC power cord. You can connect the plug of power cord to the mains.
Please make sure the voltage accepted by the unit.
9
CIRCUIT BREAKER (Manual reset button)
This is an electronic fuse for protecting the unit from possible damage. When
the unit is overloaded or the temperature inside the unit is too high, this push
type button will spring out and disconnect the power supply. Push the Breaker
to restore normal working conditions.
10
OUTPUT CONNECTOR
These connectors have two kinds: Binding post and Neutrik connector. You can
choose proper connectors according to practical need. For your safety, please
be careful when do connecting work.
3
7
COOLING FAN
This fan secures enough cooling for your amplifier. The fan speed is electronically
regulated depending on the temperature of the power devices.
For MISTRAL 2500/4000, the fans are on the rear panel.
NOTE:
For MISTRAL 6000, the fan is on the front panel.
12
9
12
14
12
13
8
CH1
BALANCED
INPUT
PARALLEL
OUTPUT
LIMITER
OFF
ON
CH2
BALANCED
INPUT
PARALLEL
OUTPUT
MODE
BRIDGE
STEREO
SERIAL
MODEL
Apparaten skall anslutas
till jordat uttag nar den
ansluts till ett natverk
CH1
OUTPUT1
OUTPUT2
POWER OUTPUTS
CH1
1+ 1-
POS NEG
CH2
BRIDGE
MONO
CH2
2+ 2-
POS NEG
BRIDGE
1+ 2+
POS NEG
CH2
1+ 1-
POS NEG
BREAKER
INPUT
INPUT
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
TIP/PIN 2
RING/PIN 3
SLEEVE/PIN 1
INPUT INPUT
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
REPLACE WITH THE SAME TYPE FUSE AND RATING
DISCONNECT SUPPLY CORD BEFORE CHANGING FUSE
WARNING: SHOCK HAZARD
- DO NOT OPEN
AVIS: RISQUE DE CHOC ELECTRIQUE
- NE PAS OUVRIR
12
3
21
3
NEW TIDE
21
3
NEW TIDE
1
3
2
11
10
7
To Next Page
Loading...
Need help?
General
