Altrad BELLE - General Safety Precautions; Health and Safety Guidelines; Pre-Start Checks and Inspections

6
General Safety
GB
For your own personal protection and for the safety of those around you, please read and ensure you fully understand the following
safety information. It is the responsibility of the operator to ensure that he/she fully understands how to operate this equipment safely.
If you are unsure about the safe and correct use of the ‘Roller Striker’, consult your supervisor or Altrad Belle.
• This equipment is heavy and must not be lifted single-handedly, either GET HELP or use suitable lifting equipment.
• Cordon off the work area and keep members of the public and unauthorized personnel at a safe distance.
• Personal Protective Equipment (PPE) must be worn by the operator whenever this equipment is being used (see Health & Safety).
• Make sure you know how to safely switch this machine OFF before you switch it ON in case you get into difculty.
• Always switch OFF the engine before transporting, moving it around the site or servicing it.
• During use the engine becomes very hot, allow the engine to cool before touching it. Never leave the engine running and unattend-
ed.
• Always ensure that no person or obstruction is in your line of travel. Watch your step to avoid tripping.
• Never remove or tamper with any guards / pipes tted, they are there for your protection. Always check guards for condition and
security, if any are damaged or missing, DO NOT USE THE MACHINE until the guard / pipe has been replaced or repaired.
• Do not operate the MACHINE when you are ill, feeling tired, or when under the inuence of alcohol or drugs.
Improper maintenance can be hazardous. Read and Understand this section before you perform any
maintenance, service or repairs.
CAUTION
Health & Safety
GB
Vibration.
Some vibration from the Roller Striker is transmitted through the handle to the operator’s hands. Refer to specications & technical data
for vibration levels and usage times (recommended maximum daily exposure time). DO NOT exceed the maximum usage times.
PPE (Personal Protective Equipment).
Suitable PPE must be worn when using this equipment i.e. Safety Goggles, Gloves, Ear Defenders, Dust Mask and Steel Toe capped
footwear. Wear clothing suitable for the work you are doing. Always protect skin from contact with concrete. Suitable ear defenders
should be used.
Pre-start Checks
GB
Pre start-up inspection.
The following Pre-start-up inspection must be performed before the start of each work session or after every four hours of use,
whichever is rst. Please refer to the service section for detailed guidance. If any fault is discovered, the Roller Striker must not be
used until the fault is rectied.
1. Thoroughly inspect the Roller Striker for signs of damage. Check that the handles are securely attached.
2. Check uid lines, hoses ller openings, drain plugs and any other areas for signs of leakage. Fix any leaks before operating.
3. Inspect the entire unit for loose bolts/nuts and retighten/replace as necessary.
4. Sectional models only - Ensure that the sections are securely assembled before use.