Your new Altrad Belle Roller Striker is warranted to the original purchaser for a period of one-year (12 months) from the original date of
purchase. The Altrad Belle warranty is against defects in design, materials and workmanship.
The following are not covered under the Altrad Belle warranty:
1. Damage caused by abuse, misuse, dropping or other similar damage caused by or as a result of failure to follow assembly,
operation or user maintenance instructions.
2. Alterations, additions or repairs carried out by persons other than Altrad Belle or their recognised agents.
3. Transportation or shipment costs to and from Altrad Belle or their recognised agents, for repair or assessment against a warranty
claim, on any machine.
4. Materials and/or labour costs to renew, repair or replace components due to fair wear and tear.
The following components are not covered by warranty.
· Drivebelt/s
· Engine air lter
· Engine spark plug
Altrad Belle and/or their recognised agents, directors, employees or insurers will not be held liable for consequential or other damages,
losses or expenses in connection with or by reason of or the inability to use the machine for any purpose.
Warranty Claims
All warranty claims should rstly be directed to Altrad Belle, either by telephone, by Fax, by E-mail, or in writing.
For warranty claims
Altrad Belle Warranty Department,
Unit 5, Bode Business Park,
Ball Haye Green,
Leek,
Staffordshire,
ST13 6BW,
GB
Tel: +44 (0)1538 380000 Fax: +44 (0)1538 380038 E-mail: warranty@belle-group.co.uk
Maintenance
The Altrad Belle ‘Roller Strikers’ are designed to give many years of trouble free operation. It is recommended that an approved Altrad
Belle dealer carries out all major maintenance and repairs. Always use genuine Altrad Belle replacement parts, the use of spurious
parts may void your warranty.
Before any maintenance is carried out on the machine, ensure that is has been disconnect from any power source.
Always ensure that on the Pneumatic roller striker that the air lubricator is kept topped up with oil. Use only Altrad Belle AL4 lubricating
oil or equivalent.
Always ensure that the drive ends are kept clean and free from concrete deposits. Ensure that the drive ends are kept lubricated to
avoid rust damage.
To keep your sectional roller striker in good working order, always check that the dowel pins (129.0.214) are tightly in position, are
not bent and are in good condition. Ensure also, that the mating faces on the adaptor plate and link rod are not damaged and in good
condition.
Typical Physical Data
Appearance
Reddish - brown
Specic Gravity (20°C) 1.107
Refractive Index (20°C) 1.427
Boiling Point (760 mmHg) 115°C
Vapour Pressure 8.5 mmHg
Vapour Density (Air = 1) 1.69
Viscosity (20°C) 20 mm
2
/s
Solubility in Water
Complete
Pour Point -60°C
Typical Working Strength
100%
Setting The
Lubrication
Introduction Of Oil In
The Standard Container
To Next Page
Loading...
