Alutech CU-TR400-868 - Safety Rules and Warnings; General Safety Information; Safety During Installation

CONTROL UNITS UTR230868 / UTR40086822
SAFETY RULES AND WARNINGS
1.
SAFETY RULES AND WARNINGS
1.1 GENERAL
Y
ATTENTION! This manual contains important safety information. Please read all information
below carefully before installation and operation. Keep this manual for future reference!
Follow the safety and labor protection rules regulated by current normative documents and this
manual. Failure to comply with the rules can lead to serious damage, serious injury andinjury,
death. Observe the requirements of standards regarding the design, installation and door op-
eration (EN12604, EN12453), as well as other possible local rules and regulations.
Y
ATTENTION! Installation, connections, adjustment, commissioning, maintenance, dismantling
and disposal of the product must be carried out by qualied (professional) and trained specialists
(EN12635), competent and specialized organizations. Installation, programming, adjustment and
operation of the product in violation of the requirements of this manual is not allowed, asthis
can lead to damage and personal injury.
Do not start installation and operation of the product if you have any questions or if you do not
understand anything. If necessary, contact your nearest ALUTECH service or oce.
It is not allowed to make changes to any elements of the product design and use the product for
other purposes. The manufacturer is not responsible for any damage caused by unauthorized
changes to the product or misuse. When carrying out any work (installation, repair, maintenance,
cleaning, etc.) and electrical connections, disconnect the power circuit. If the switching device is
out of sight, attach a plate: ‘Do not switch on. People are working’ and take measures to eliminate
the possibility of erroneous voltage supply.
The manufacturer and supplier do not exercise direct control over the installation of the product,
and are not responsible for the safety of installation, operation and maintenance of the product.
The company reserves the right to make changes to this manual and product design without
prior notice, while maintaining the same functionality and purpose. The contents of this manual
can not serve the basis for legal claims.
1.2 DURING INSTALLATION
Y
ATTENTION! The condition of all components and materials must be suitablefor use and comply
with applicableregulatory documents. The used tools and materials must be in full working order
and comply with applicablesafety regulations, standards and instructions.
Make sure that the product is used correctly (section ‘2. Product description’). The installation
location of the product must comply with the declared temperature operating range indicated
on the product label.
Remove all unnecessary parts (cables, ropes, angles, chains, etc.) before installation and turn o
all unnecessary equipment.
Make sure that there is enough space for installation and operation of the product.
Make sure that the drive system devices are protected against accidental impact by passing
vehicle. Otherwise, provide protective equipment (fences).
The surfaces of the installation locations of the devices must be durableand must be used as
a reliableand rigid support, eliminating vibration. Otherwise, take measures to strengthen the
installation locations. The control unit and other stationary control devices must be located