V-7
Alarm code Cause Remedy Remarks
Runout of saw blade was
detected.
Clear alarm, reset runout, and
change saw blade or reduce
cutting rate.
E-007
(option)
Runout detector is faulty. Contact AMADA.
Sawhead rises to
upper limit and
stops.
E-008
PLC backup battery ran
down.
Clear alarm. Contact
AMADA for changing run-
down battery.
This alarm occurs
only when
hydraulic pump
motor is running.
(Machine can be
operated without
changing run-down
battery, but
machine
parameters and
cutting data may
be erased from
memory when
power is turned
off.)
E-009 Backup battery for cutting
data setting controls ran
down.
Clear alarm. Contact
AMADA for changing run-
down battery.
This alarm occurs
only when
hydraulic pump
motor is running.
(Machine can be
operated without
changing run-down
battery, but current
time may be
improperly
displayed on LCD
screen once power
is turned off.)
During head-end positioning,
work projection from rear vise
is 20 mm {0.8 in.} or less.
E-011
(option)
During head-end positioning,
amount by which rear vise
can move backward is small.
Clear alarm, and properly set
work.
Hydraulic pump
motor stops.
E-101 Saw blade motor thermal
relay (FR1) tripped.
Reset thermal relay, and clear
alarm.
Hydraulic pump
motor stops.
E-102 Hydraulic pump motor
thermal relay (FR2) tripped.
Reset thermal relay, and clear
alarm.
Hydraulic pump
motor stops.
E-103 Cutting fluid pump motor
thermal relay (FR3) tripped.
Reset thermal relay, clear
alarm, and check cutting fluid
filter.
Hydraulic pump
motor stops.
E-105
Solenoid valve or valves are
faulty, and circuit protector
(QF2) is turned off.
Check solenoid valves, turn
on circuit protector (QF2), and
clear alarm.
Hydraulic pump
motor stops.
To Next Page
