IV-24
Using multi-vises (optional)
Use the multi-vises as described below.
NOTE
O When stack cutting workpieces, check that they are each securely clamped,
and take special care so that they do not vibrate. Vibration adversely affects
the life of the saw blade.
1 Open the front and rear vises wider than the nest width of
workpieces, and stack the workpieces on the front and rear vise
tables.
2 Install the multi-vises
on the front and rear
vises. They need
not be fixed at this
point of time.
3 Connect the hydraulic hoses of the multi-vises to the plugs of the
front and rear vise cylinders.
4-)4 815-
4 Install the stack
cutting fence on the
work tray.
The stack cutting
fence is designed to
prevent the stack-cut
pieces from collapsing
on the work tray.
Securely fix the stack
cutting fence to a
width slightly greater
than the width of the
nest.
To Next Page
Loading...
