VI-2
CHECKING BEFORE START OF DAY’S
WORK
Before starting the machine every day, check the following items.
Hydraulic oil level
Check that the hydraulic oil
is filled to the middle of the
sight gauge.
If the hydraulic oil level is
lower, remove the hydraulic
unit cover at the left side of
the machine, remove the
filler cap, and add one of
the recommended
hydraulic oils into the tank.
FILLER
CAP
SIGHT
GAUGE
Recommended oils: Esso Teresso 32
Shell Tellus Oil C32
Mobil DTE Oil Light
(ISO VG32 equivalent)
Tank capacity: 30 liters {7.9 US gal} for HFA-250 and HFA-250W
40 liters {10.6 US gal} for HFA-400 and HFA-400W
Cutting fluid level
WARNING
O If the tank is low on the cutting fluid, the
cutting fluid may not be supplied in
sufficient amounts, markedly shortening
the life of the saw blade. If the cutting
operation is continued in this condition, a
fire may occur.
Check that the cutting fluid
is filled to a little above the
middle of the sight gauge.
If the cutting fluid level is
lower, pour the cutting fluid
into the spiral portion of the
chip conveyor.
SIGHT
GAUGE
Tank capacity: 85 liters {22.4 US gal} for HFA-250 and HFA-250W
120 liters {31.7 US gal} for HFA-400 and HFA-400W
To Next Page
Loading...
